2008年2月4日星期一

用 Dev Team 的 1.1.3 Jailbreak 上113 !!!

1.必須為Jailbreak過的112版本. 如果係111版本 : 安裝oktoprep後升級到112版本, 然后Jailbreak. 如果 已經是113版本又希望重新開始:請恢復至111版本, Jailbreak(通過jailbreakme.com) 安裝oktoprep, 升級至 112版本, 然后Jailbreak.
2.安裝BSD Subsystem(需要1.5以上版本). 在設置界面中將Auto-Lock設置為Never. 安裝SSH以防出現問題.
3.將 http://www.modiphone.net/repo 加到Installer資源. 刷新資源. 安裝Modiphone.net下的“Jailbreak 1.1.3”. 這個過程可能需要20分鐘以上. 完成后你的iPhone將自動重啟, 之后便是完全Jailbreak的113了.
4.如果你要同步聯絡人, 記事本之類, (新的或者以前的Jailbreak)請安裝“1.1.3 Sync Fix”,這個也在Modiphone.net下.

The Official dev-team jailbreak has been fixed and re-released. It is available to install directly from our Installer repo. Here is our complete guide:
1. You must be running 1.1.2 jailbroken. If you are on 1.1.1: install oktoprep, update to 1.1.2, and jailbreak. If you are on 1.1.3 already and want to start fresh: restore to 1.1.1, jailbreak (with jailbreakme.com), install oktoprep, update to 1.1.2, and jailbreak.
2. Install BSD Subsystem (version 1.5+ required). Set auto-lock to NEVER in preferences. Install SSH as a fail-safe.
3. Add http://www.modiphone.net/repo to your Installer sources. Refresh sources. Install “Jailbreak 1.1.3″ under Modiphone.net. This can take 20+ minutes. Your phone should reboot when done, and you will be in 1.1.3, fully jailbroken.
4. If you are experiencing syncing issues of contacts, events, etc, (with new or from the earlier jailbreak) install “1.1.3 Sync Fix”. This is also on our repo, under Modiphone.net.
Enjoy!
If you need help, feel free to ask in our new forums.
Important notes:
-If our repo is already in your sources, REFRESH your sources! The version number for the package should read 2.0.
-You need a good wifi connection. The script downloads the firmware from Apple which is very large.
-The script can take a long time, and will not always reboot your device when finished, for reasons out of anyones control. If you feel it’s taking too long, I would say 30+ minutes, go ahead and reset it. It should boot into 1.1.3.
-If it finishes and you are stuck in Recovery Mode, fear not! Simply run iBrickr and it will automatically detect and fix this. Again, this is out of our control. This is common with all updates/jailbreaks.

沒有留言:

發佈留言